Ask Experts Questions for FREE Help !
Ask
    mingjang's Avatar
    mingjang Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 9, 2007, 11:19 AM
    Power washer
    Pull cord won't retract,oil is full.:confused:
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    May 9, 2007, 11:53 AM
    Will not retract or pull? If it won't pull hold the gun open to relieve pressure.

    Don
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Husky Power Washer [ 2 Answers ]

How do you remove a broken wand that is inside the spray nozzle?

Power Washer [ 2 Answers ]

Troy Bilt Power washer with Briggs and Stratton engine, Pull start, no primer only choke. New Spark Plug Won't Start any suggestions

Seems like no power to my washer [ 2 Answers ]

I have a Kenmore Elite Catalyst washer (model # 11022052100) that was working fine, then the next time I went to use it I pushed the buttons to begin washing - the lights lit up - the water flowed through the detergent cup for a few seconds - then everything turned off. I again pushed the buttons...

Power washer [ 1 Answers ]

My power washer is gas powered and it runs until i pull the trigger it cuts right off there seems to be a problem with pressure not building up what's wrong with it if i start it up it will keep running till i start washing , sometimes no water comes out or in spurts

View more questions Search