Ask Experts Questions for FREE Help !
Ask
    pattyg2's Avatar
    pattyg2 Posts: 480, Reputation: 27
    Full Member
    		  
    #1

    May 2, 2016, 01:25 PM
    Honda HR214 self propelled gas push mower
    I am installing a new roto stop cable and need to know how to secure the cable to the roto stop under the engine. It has a "washer" and do I just force it on the end of the cable??
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    May 2, 2016, 01:38 PM
    Try this
    http://www.youtube.com/watch?v=w9TS8vl0Cjg
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honda HR214 self propelled gas push mower [ 0 Answers ]

I removed the rear discharge guard on HR214 to paint it. Now I can't figure out how the spring goes back on.

Push mower self propelled will not start [ 2 Answers ]

L bought a 22" cut that is with automatic start and self propelled. This is a Craftsman 725 series briggs and stratton engine. Model is 917.370440. The lawn mower started with the automatic start for about a minute. Started it back and it mowed for about 2 minutes. Stopped and have not been able to...

Troy bilt 3.5 self propelled push mower won't fire even with a new spark plug? [ 0 Answers ]

Troy bilt 3.5 self propelled push mower won't fire even with a new spark plug?

Toro 6.0hp self propelled gts xl push mower [ 2 Answers ]

I'm mike form Florida. I have a toro 6.0hp self propelled gts xl push mower that won't start. The engine will turn over and run for 5 to 10 seconds and then shut off. This problem started about 4 months ago had has gotten steadly worse as time goes by. Does anyone have any information to...

Sears Self-Propelled Push Mower Won't Start [ 3 Answers ]

I own a Sears Craftsman 22" 6.5 HP Self-Propelled Push Mower (Model #917375520) that will not start. I noticed that the circular metal contact inside the spark plug boot was pushed below where the spark plug would normally snap in. I pulled the round metal clip forward and snapped the boot onto...

View more questions Search