Ask Experts Questions for FREE Help !
Ask
    jbenson06's Avatar
    jbenson06 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 15, 2014, 05:54 PM
    John Deere 155C blows fuse when I engage the blades
    John Deere mower 155c the fuse blows when I engage the blades.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jul 19, 2014, 12:11 AM
    Hi,
    It is likey a bare wire down near the clutch touching the frame. Could be a shorted PTO switch or key switch, but I would go looking for the easiest and least expensive first. It is a dead short nonetheless.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John deere blades will not engage [ 1 Answers ]

My riding mower was working fine... I switched the blades off so that I could put the mower in reverse... now the blades will not engage... any suggestions?

John Deere model 145 runs perfect until I engage blade switch .blows fuse put in new [ 1 Answers ]

Runs perfect until I engage blade switch .blows fuse put in new switch dose same thing Blows fuse John Deere model 145

John deere 155c pto won't engage [ 5 Answers ]

Okay here goes, my wife was mowing and got of the 155c to pick something up. The tractor died and I found the 20 amp fuse blown, I replaced the fuse twice and the tractor started up, but the mower would not engage. I replaced the electric clutch assembly and plugged it in only to find it still does...

John deere 318 blows fuse when blades are on [ 1 Answers ]

I have a john deere 318 when I engage the blades and run it fore 10min the battery light comes on and blows a 29amp fuse,, help

John deere 455 - blows fuse when I engage the blades - any ideas? [ 4 Answers ]

The 455 - with a 22hp diesel engine. The fuse blew and the mower would not start. Replaced fuse - now it starts but when I engage the blades the mower dies and fuse is blown again. Any suggestions?

View more questions Search