Ask Experts Questions for FREE Help !
Ask
    bill jr's Avatar
    bill jr Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 28, 2012, 03:33 PM
    Push rods
    One push rod has a oil hole through it the other doesnot. Which rod goes to the intake valve?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 6, 2012, 11:29 AM
    Hi,
    You did not state and engine brand. Often one is a steel-based material(magnetic) and it usually goes to exhaust. At any rate that is where I would try it.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Moen push/pull crystal faucets hard to push/pull [ 1 Answers ]

Hi. I have Moen crystal looking single facuets (I don't like) that are about 7 years old, came with the new house. They started getting dirty and so I took the handles off and cleaned them with soap and a scum cleaner and used a screwdriver to get some of the "plaque" out. Now, even after...

Ground Rods [ 1 Answers ]

I installed two ground rods for my main electrical box when I built my house and they were passed by the local electrical inspector. A year later I removed some of the soil near the rods and installed a three foot retaining wall the length of the house. The rods are still eight foot into the...

Anode rods [ 5 Answers ]

We put a new water heater in our farm house in October. A few weeks after installation we started getting rotten-egg smelling water. We changed the anode rod to what we believed to be an aluminum anode rod. Water was good for a few days then started smelling again. We just took that rod out of...

13.5 B&S how to correctly install and adjust push rods [ 1 Answers ]

Hi, I have a 13.5 B&S O.H.V. mtr. That wouldn't start, I finally found that the rocker arm had come off the push rod. Installed the rocker arm back on and it ran for about a minute and came back off. So I took the push rods off and found that one had bent. I ordered replacement parts through...

What could bend push rods on john deere gx345 [ 2 Answers ]

Hi, I have a 2 yr old John Deere GX345 riding lawn tractor with the Kawasaki motor. Serial number mdg3458114794 with a 54inch cut mower deck. It has 360 hrs on it all mowing my 4 acre lawn. Recently after taking a break in mowing, I tried to restart my tractor and it's wouldn't start. I...

View more questions Search