Ask Experts Questions for FREE Help !
Ask
    charlie1977's Avatar
    charlie1977 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 25, 2012, 09:09 PM
    Briggs and stratton carb problems
    I have a 18.5hp briggs opposed cylinder engine. It has started using about twice as much gas to mow. The airfilter is clean when you run it full throttle it seems to flood some and run rough and has lost power and it smokes a little black smoke. But when you run it at an idle or about half throttle it seems to run good. It starts easy. I have cleaned the carb 4 or 5 times and tried adjusting the float so it doesn't get as much gas in the carb and I have put a complete kit in the carb it included new gaskets for the carb and gaskets and diaphram for the fuel pump a new needle and seat and adjustment screw I replaced all of this and even if I shut the adjustment screw all the way it still runs all of this has helped a little but it still has the same basic problem just a little more power and seems to run just a little bit smoother at full throttle but still not as smooth as it should be and when you put it under a little load it almost stalls the engine it has good fire and compression and the problem started all at once. The model # is 42a707 the type # is 1238-01 and the code # is 9705125a any help would be greatly appreciated
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Aug 5, 2012, 11:43 AM
    Hi,
    Despite the fact that you say the compression is good, I would say you have a partially blown head gasket. The use of excess fuel and almost stalling seem to tell me this.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs and stratton carb? [ 9 Answers ]

Got a murray push mower w/3.5 hp classic 9d902 2005 b2 00122851 b&s motor--primer bulb rotted away-installed new snap in bulb--opened up carb checked out for any gummy build up or bulb fragements -found none----primer won't squirt gas in carb unless you pour a little gas in carb--starts great then...

Briggs&Stratton Pulsa Jet Carb problems [ 9 Answers ]

I'm having trouble starting an older aerator with a B&S 3.5hp horizontal shaft engine with a Pulsa Jet carb. I've changed diaphragm, and carb-to-fuel tank gasket. It can be started and run on starter fluid, but doesn't seem to pump gas into carburetor. What else to look for?

Briggs and stratton carb issue. [ 1 Answers ]

This tiller was toast. Cracked block,piston seized in its bore, gas tank full of water. So I welded the block, freed the piston, lapped the valves, replaced the head gskt. Cleaned out the tank, rebuilt the carb. (with new fuel pump,pick-up tube, mixture needle,and many hours of soaking.) Now it...

15 HP Briggs and Stratton, Oil in Carb [ 1 Answers ]

Briggs 15 HP OHV, Model 311707, type 0138-E1, code 010228ZE. 151 hours on engine. Large volume of oil being blown into carb/air cleaner. Heavy clouds of gray smoke. Oil level on dip stick normal. Engine loads up and dies. What are possible causes and solutions? Woodman 65

Briggs and stratton carb problems [ 8 Answers ]

I have been having problems with my briggs and stratton 12.5hp motor! The carburator keeps getting too much gas into the float reservoir and gas comes out. I recently purchused a brand new carb and installed it but still seam to get too much gas to the carburator when I go to start it. Could it be...


View more questions Search