 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a 5hp Craftsman tiller 298351 Wondering about oiling chain
The guard around the chain that goes to tines seems completely sealed. There is the shaft that runs through it off the top belt pulley of course. I am thinking since it is completely sealed it might have oil permanently inside? Would hate to screw it up over some maintanence I failed to do, It runs and tills great!
|
||||
Check out some similar questions!
Craftsman 5 hp tiller briggs and stratton engine - tiller won't start anymore
[ 8 Answers ]
Craftsman 5 HP Briggs and Stratton tiller front tine model 917298352 I bought it yesterday. It is approx 4 years old and was only used twice. I put some gas in it and it started quickly. Ran fine for about 30 minutes and then started revving up and down and then eventually died. I could...
Older Craftsman Tiller w/5hp Briggs and Stratton
[ 11 Answers ]
I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...
I have an older model 5hp 17 inch craftsman rear tine tiller
[ 1 Answers ]
Where do I find the model #
5hp MTD FRTine Tiller
[ 1 Answers ]
My tiller runs fine for five to ten minutes then dies.:confused:
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
