Ask Experts Questions for FREE Help !
Ask
    vbalex's Avatar
    vbalex Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 19, 2010, 08:08 AM
    Bolens BL100 starter cord replacement
    On Bolens BL100 string trimmer: How do you remove the "palnut" holding the cord pulley in place? Does it screw in or pull off? I fear breaking it. Thanks
    gideon51's Avatar
    gideon51 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Apr 21, 2011, 01:32 PM
    It pulls off. Grab the edges with large pair of needle nose pliers and twist while gently pulling it off the end. Replace by reversing the procedure.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bolens BL100 weedeater won't run for long. [ 4 Answers ]

Have a Bolens bl100 weed eater. Can't seem to keep the thing running. It is roughly a year old. Has run just fine up to this point. Put the carb choke on 1... pull the cord 5 times until the engine kicks over and wants to run. Then I move the carb choke on 2 and pull the cord. The engine runs for...

Bolens transmission belt replacement [ 2 Answers ]

Hello friends. Trying to replace the transmission belt on a Bolens model 13AM762F765 (15.5HP 6 speed) tractor. Model year is 2006. Purchased from Lowe's. Owners Manual states that this replacement must be accomplished by a certified service center. To replace a belt? Come on --- So, my...

Bolens 2136 rider. Starter sounds like it is grinding. Won't start! [ 0 Answers ]

Was running fine but now when I try to turnit over it makes a grinding noise. Any suggestions?

Push Mower Starter Cord Replacement [ 1 Answers ]

John Deere Push Mower-Starter Cord Broke What are the replacement steps?

Weed Eater starter cord replacement [ 1 Answers ]

I have a Weed Eater model Quantum XM, model # WE986RA with a broken starter cable. I checked your previous answers but I don't see how to get the housing off. It seems to be riveted. It doesn't seem like a good idea to drill the rivits without checking first.

View more questions Search