Ask Experts Questions for FREE Help !
Ask
    RWEAST's Avatar
    RWEAST Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2010, 10:01 AM
    I have a John Deer L100 with an Intek 17hp OHV that won't start.
    I have power, fuel but no spark won't fire could the spark plug be the problem or is it the silinoid and if it is what is the gap distance between it and the flywheel. Worked on it till 2 AM the other night trying to get it running please help!
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Apr 6, 2010, 07:09 PM

    The solenoid isn't next to the flywheel you must be talking about the coil,I use a index card between the coil and the magenet on the flywheel,
    Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Have a john deere L100 no start [ 2 Answers ]

John deere L100,NO START,took off starterand had it checked and its fine. I HAVE 12 VOLTS AT THE BATTERYand 12 volts going into the senolid but no volt coming out of the other side of the senolid and no volts at the starter.CAN I jump the starter senolid like the old FORDS or will it short the...

Craftsman DYT 4000 with B&S Intek 18.5 OHV turns over, has compression, won't start [ 1 Answers ]

Hi, I find myself in the unfortunate position of not knowing the circumstances under when this first occurred as I was away on vacation. All I know is my Craftsman DYT 4000 with Briggs & Stratton 18.5 OHV Intek ( 31P7770348E1 from engine tag) engine has run flawlessly for the past 3 years and...

John Deer Riding Riding Lawn Mower Won't Start [ 9 Answers ]

Hello, I have a John Deer Riding Lawn Mower LX 173. It won't start. It ran fine last fall and I have a new battery on it. It will start with the help of starting fluid and run for just a second and then shut off. I found a hose disconnected on it but I'm not sure where it goes. It was laying...

B&S 18.5hp OHV Intek must run with choke on- no power [ 2 Answers ]

Craftsman DYT4000 mower with Briggs & Stratton 18.5hp OHV Intek engine started putting out some black smoke when starting last week. Today it started fine, put out a puff of black smoke, and seemed to run fine until I started to mow. It died as though it was fuel starved. Restarts easily but will...

John deer sabre won't start [ 1 Answers ]

I have a john deer sabre model 1438 gear. There is a wire that comes from a fuse that I do not know were it goes. I hooked it directly to the posative on the battery and I blow my fuse. I hook it to the selenoid were the powere wire connects from the battery and the fuse blows. I hook it to the...

View more questions Search