Ask Experts Questions for FREE Help !
Ask
    cagold's Avatar
    cagold Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 6, 2009, 01:58 PM
    Remove primer bulb on Ryobi 775r
    I need to replace the primer bulb on my Ryobi 775r weedeater. Any ideas on how? It appears that the carb plate has to be removed... surely not.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jul 6, 2009, 03:43 PM

    Do you have the new replacement bulb yet? Many bulbs are simp[ly pressed in and snagged out. Never replaced one on a Ryobi but take a close look at your new bulb. You may be able to just deform it and press it in place. Try prying the old one out with a small screw driver
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ryobi gas trimmer primer bulb hookup [ 5 Answers ]

The gas lines to the primer bulb of my Ryobi 790r string trimmer primer bulb have literally rotted away and I must replace them. There are 2 connections to the bulb,2 to the gas tank and 2 to the carburetor. I need a diagram to tell me how these should be interconnected and nobody seems to know....

Primer bulb sticking [ 1 Answers ]

2 cycle weedeater (craftsman) pushing in primer bulb and it stays in, will not prime. Any suggestions?

Echo primer bulb [ 4 Answers ]

How do I replace the primer bulb on my Echo grass trimmer model 1E SRM-2400? I purchased to part but can't get to the 4 screws to replace. Thanks Dilady

Primer Bulb [ 2 Answers ]

I have an older mower that runs OK. However, lately after about 10 min of running, it starts to choke out. When this happens, the primer bulb is sucked back into the mower. I can wait a few minutes or just manually pull the bulb back out and will run a few more minutes. What would cause the bulb to...

Primer bulb for push mower [ 3 Answers ]

I have a push mower that only stays running when the primer bulb is pushed in. When I let go of the bulb, it quits running. Does this mean there is a hole in the primer bulb. When I hold the primer bulb in it runs like it would normally. Any suggestions?? :confused:

View more questions Search