Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
11.5 to 11 hp briggs
[ 1 Answers ]
Will an alternator and armature from a 11.5 briggs mdl#28T707 type 1154 fit on a 11hp briggs mdl#252707 type 0130?
14/hp briggs
[ 2 Answers ]
Hi i am trying to repair a 14/ hp briggs motor. This motor has ohv where i have never had a chance to work on i am from old school and not used to this newer equipment. Here is the problem first he carb was overflowing with gas i took it apart and cleaned everything with parts cleaner and hoped i...
12.5 briggs
[ 1 Answers ]
I have a 11hp rear engine snapper. The motor shut down on me so I took it off and replaced with a 12.5hp. The only 2 wires the 11hp had was a starter wire and another that went inside the lid. This 12.5hp has those 2 wires plus 2 more that are both coming out of the side together in the same...
18.5 HP Briggs
[ 5 Answers ]
Hello everyone, I have a Craftsman lawn mower with a 18.5 Briggs single cylinder that will not crank over. Have replaced the starter with a new one and it still does not crank over. Someone suggested checking the values and the valves were a little off so we fixed them. Sometimes it will...
12.5 Briggs won't run
[ 5 Answers ]
I posted a question earlier about a Murray mower wiring problem. Thanks for the info. I found the coil was dead and traced all the wiring. Now I am getting fire and gas, but it will not run - or even sputter. The key isn't sheared, and as far as I can tell the bottom end hasn't been opened, but it... View more questions Search
|