 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Murray tractor mower 12hsp
Greetings,
I am working on a Murray 12 hsp tractor mower that has been virtually laid up for 7 years, and is only approx. 8 years old since the owner(my next door neighbor) died. I have change all fluids and had the carborator repaired and cleaned. I have a brand new battey replaced. And it has started and ran for at least 15 minutes on two occasions since its' minor repairs. At present, it's not even clicking on from the battery. I have a fully charged battery and am not sure how to test the electrical components from the battery to the starter? Could you provide some tips to check and how to hook up my amp meter to check say, the ignition switch ? Which setting should my amp meter be on and the like? Or since there appears on one main red wire from the ignition to the starter, how do I check the starter? Or is there a free online manual that you could refer me to for small or 12 hsp motor/mowers? I would be indebted to your services and humbly await your response Sincerely Cajunboy |
||||
|
||||
|
Try this:
ed-qutips - Briggs & Stratton Also, under Google, typing in Murray riding mowers brings some good sites. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
How can I check the transmission fluid level in a Murray Select Wide Body LT Lawn Tractor, 21 hp, 46" cut, MFG date 8.21.02. I can find NO help at the Murray website. Thanks, Phillip
Model 405004x99, 2 year old Tractor with a Briggs & S. 12.5 hp engine has a very hard time starting. It has a clean air filter; good in-line fuel filter, clean/fresh gas; oil is new and gets spark from the plug. I have had to jump start the battery from a car and (on a different occasion) a...
iI have a Murray lawn tractor that will not endage the transmission. When I release the lever from the push mode to the drive mode it's still in the push mode. It's a model 425620X92A. CC
I have a 42 inch murray lawn tractor I got from somebody and I was rebuilding it. I took the carb off and cleaned it out, rebuilt it. Its running fine now finally after 4 days of working on it. My problem is I have to have the brake down to start it and I sit on the seat and when I take my foot...
View more questions Search
|
