Search:

As MOWERMAN2468 suggested, I removed the carb and cleaned it out as best I could with carb cleaner (didn't actually rebuild it). Also cleaned out all three holes on the screw that holds the fuel...

I bought the mower in 06/2003. Not that old but not no where new either. The bowl did have fuel in it but it also had some grayish sludge built up on the bottom. I did dump out all of the fuel...

When I removed the fuel bowl I did notice that there was a small float similar to what you see on an automotive fuel pump. What should I use to clean the carb? If I take it apart, do I need to...

I have a MTD 4.5 HP Briggs and Stratton push mower. I've emptied the gas tank and put fresh gas in it. I changed the oil. I replaced the spark plug and air filter with new ones. I also removed...

It's not a load-bearing wall. I've heard about a flat stud wall but could you elaborate? I've also thought about just removing the wall with door all together because all it does is separate the...

I have to move my toilet over an inch away from the wall per inspector's order. The top of the main sewer line is 4" below ground level encased in the concrete foundation with a 4" 90 degree street...

Tom I've attached a picture to show that I need to move away from the wall on the right. The remainder of the original closet flange is still glued onto the elbow. It was a closet flange that fit...

I've broken up the concrete around the elbow and have found that the elbow ends at ground level. The actual sewer line sits only about 4" below ground level so I think there isn't an elbow that I...

"Speedball 1" I found the offset closet flange you have pictured at Home Depot. The problem that I ran into is that the 4" street elbow that is at the end of the sewage line has a spigot end (see...

The toilet is to close to the wall so the inspector dinged me on it. The only reason the wall is so close is because it was moved in that direction to fit a dual sink vanity that the wife wanted. I...

I have to move my toilet over an inch from the wall per inspector's request. I have searched the internet and have not found an ABS offset closet flange that would work for me. I did however find a...