Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
B&S Rocker Arm Adjustment
[ 1 Answers ]
I have the specs for clearance on my OHV system. It is a Briggs and Stratton 14.5 OHV I/C motor. I am trying to get the rocker arms adjusted properly. I have never done this with the type nuts that we have on here. In the middle of the nut, there is a setscrew used for the adjustment. Could someone...
15HP OHV Briggs - Rocker Arm Question
[ 3 Answers ]
Greetings, I have a 15HP OHV Briggs engine on a Craftsman Lawn Tractor that was purchased in 1994. Recently the rocker arm stud backed out on the exhaust valve, I assume from years of vibration. I removed both studs and put loc-tite on them and reinstalled. My concern is that the rocker arms...
Foundation j bolt retrofit
[ 4 Answers ]
House has never had any tie down j bolts on The mud sill. However concrete blocks are hollow and usually They fill down two blocks with mortar and place the J bolt in the wet mortar poking up through holes You bore in the mud sill. Can I cut out the face of the block on one web, Put the j... View more questions Search
|