Ask Experts Questions for FREE Help !
Ask
    ecm1949's Avatar
    ecm1949 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 2, 2011, 07:37 AM
    Primer bulb gets too full
    I have a Ryobi 725r Weedeater. Once the primer bulb is full you cannot press it anymore. It's like the gass gets so far in the lines & will not flow any further and backs up in the bulb. I see fuel go through the top line to the carbarator but once full it stops.

    How can I Fix-It?

Check out some similar questions!

Replace primer bulb Echo trimmer [ 3 Answers ]

Is there any magic to replacing the primer bulb on an Echo weed trimmer? Sure sounds like the thing *wants* to start now, but no luck?

Primer bulb sticking [ 1 Answers ]

2 cycle weedeater (craftsman) pushing in primer bulb and it stays in, will not prime. Any suggestions?

Echo primer bulb [ 4 Answers ]

How do I replace the primer bulb on my Echo grass trimmer model 1E SRM-2400? I purchased to part but can't get to the 4 screws to replace. Thanks Dilady

Primer Bulb [ 2 Answers ]

I have an older mower that runs OK. However, lately after about 10 min of running, it starts to choke out. When this happens, the primer bulb is sucked back into the mower. I can wait a few minutes or just manually pull the bulb back out and will run a few more minutes. What would cause the bulb to...

Primer bulb for push mower [ 3 Answers ]

I have a push mower that only stays running when the primer bulb is pushed in. When I let go of the bulb, it quits running. Does this mean there is a hole in the primer bulb. When I hold the primer bulb in it runs like it would normally. Any suggestions?? :confused:


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.