Can anyone tell me how to wire a 12HP 38" Cut Murray Riding Mower from the switch to the solenoid to the battery. I have one wire that attaches with a clip to a post on the solenoid and a yellow wire that goes to the switch or the seat cutoff and a large red wire with a smaller red wire attached...

I was given a Murray Riding Mower that had nothing when the key was turned . I replaced the blade disengage safety switch and the mower started. I get nothing again when the key is turned. I replaced the cellenoid, battery, BDS switch again, and had the starter checked. The seat safety was...

I have a model year 2000 Murray lawn tractor, 14.5 hp, 40" cut - It always ran perfectly, but just a couple days ago, I cut my yard & shut the engine off & parked it - then I went out to start it and move it later - the dog gone thing starts fine, (no problem with the engine at all), but when I try...

I hope to disengage the 3-4 safety switches on my Murray riding mower in an attempt To use the mower to pull a plugger. I've located the wiring diagram but I'm not sure How to read it. I hope to jump from wire to wire by inserting a wire but I'm not Sure where the switches are located. I'm...

My mower runs but only as long as the battery has a charge. And then it dies, so what could be the problem? Please help I have a huge lawn and a push mower just doesn't get it!!