 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
John deere not running
I have a L120 with a 20hp Briggs it sounds like it is running on 1 cylinder until 3/4 throttle to full you can here the difference. I had it running just off idle took off the air cleaner cover, poured a little gas in the air inlet that wasn't firing and it fired right away, Is it possible to have a clogged jet or something? I replaced the fuel filter, and found the fuel lines a bit suspect as they are hard and brittle. It has 343 hours on the engine, and is a 2005. Thanks
|
||||
Check out some similar questions!
We only have about 30 hours on this 1.5 year old garden tractor, as it only really needs to be used about once a year when the wild grasses are very tall and they're getting quite brown and becoming a fire hazard. Thus, it had been sitting unused for a few months when I tried to start it to move...
This tractor has not ran in a few years but is in good condition. I can get it started just fine but have to spray gas directly into the carb air intake to keep it running. It will run as long as I do this. Any suggestions on what to check first? There is gas in the fuel filter. Should I check...
After sitting this winter I bought this mower and he just filled it up with fresh fuel now when I spray ether is air filer box it will only run for a few seconds?
Here is the problem. For the past few years I had to jump start the mover due to the battery never charging. This year I had to move to the starter for the positive because it would not jump from the switch. A few times it worked and would stay running. Now the thing will run if I spray fluid into...
I have a john deere lt 160 with a kohler engine. It began to rev at a high rpm when the blade is not engaged, I am afraid it will blow the engine
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
