Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Craftsman 16 hp 42 in. Lawn tractor won"t engage when clutch is released.
[ 1 Answers ]
Once the mower is started, the engine runs fine, until the clutch/brack pedal is released, then the engine quits. Where would be the first place to check for a problem? Grateful for any answers!:)Thanks!
Jeep Cherokee 92 A/C clutch won't engage
[ 5 Answers ]
Hi. My A/C stopped working one day. I troubleshot it with a meter (I am an EE). Once I short the relay contacts the clutch will engage, which means, that the Low pressure switch and everythin that is in series with the clutch relay contact group is OK. Now the relay coil is hooked up to 12V via...
The clutch does not engage on my Sears Craftsman 48'
[ 1 Answers ]
Hello everyone! I am new at this and signed up because I have a problem. The electric clutch in my lawn tractor Sears Craftsman 42' do not engage the blades. It started normally and then it disengaged. It did the same for a couple of times and then it stopped engaging completely. Does any one...
Engine starts, won't engage
[ 3 Answers ]
I have a 16.5 hp Craftsman Lawn Tractor (2001) Worked fine one day. Next day started fine, engaged and ran about five feet, jerked a few times. I shut off, checked it out. It started right up again, but would not engage. No motion forward or reverse. Sears tech support suggested parking brake... View more questions Search
|