Ask Experts Questions for FREE Help !
Ask
    Motopowersports's Avatar
    Motopowersports Posts: 2, Reputation: 2
    New Member
     
    #1

    Mar 15, 2013, 07:17 PM
    Intake problem? Fuel problem?
    Well, I have a craftsman briggs & stratton 500cc 17.5 hp. Silver edition riding mower. I have cleaned the carbs on it three times already. I can only get it to start if I take off the airfilter and choke it by covering the intake hole. Only leaving a small gap. Then only will it stay on. Don't know what to do next?
    garyg1959's Avatar
    garyg1959 Posts: 3, Reputation: 1
    New Member
     
    #2

    Mar 16, 2013, 01:15 PM
    There is a leak somewhere, did you replace the gaskets at carb.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1993 honda accord 10th anniversary edition -problem with emc and or fuel problem [ 3 Answers ]

Thank you for your quick response and research in helping me with my problem that I posted yesterday.I am having a hard time trying to understand what is going on with my car. History of the car: purchased in 1996 with 59,372 miles, now have 132,000 miles and it has all original factory parts...

I have gas leaking from air intake and out the muffler what is the problem [ 0 Answers ]

I have gas leaking out the air intake and out of the exhaust system on my troy built lawn mower what is the problem

Replaced intake gaket on my 2001 altima and still has the problem [ 1 Answers ]

I replaced the intake gasket on my 2001 altima 2.4 and now the car is shaking even more now What went wrong?

Airlock problem on water Intake valve into House [ 3 Answers ]

I have a house that is 4 1/2 years old. I am on city water and all of a sudden about just over 1 month ago I started having a banging problem on the major water intake Valve into the house when I flush the toilets, washer starts filling up with water, turning on the Taps in the basement. This...

Problem with Toyota Tundra K&N Intake Kit! [ 7 Answers ]

Hello, I just installed a K&N intake kit on my 2000 Toyota Tundra V8. After installing it I drove my truck it sounded great and then after 5-10min driving I started to hear rattling noise when accelerating around 45mph. I took it off put my stock intake and there was no rattling noise . Yet again I...


View more questions Search