Ask Experts Questions for FREE Help !
Ask
    vickie1234's Avatar
    vickie1234 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jun 6, 2012, 10:04 AM
    Huskee mower troubleshooting
    My mower will start but after it starts it sounds like it is running out of gas. We have changed the fuel filter and hoses going to tank and carb. What could be causing this
    vickie1234's Avatar
    vickie1234 Posts: 2, Reputation: 1
    New Member
     
    #2

    Jun 6, 2012, 10:05 AM
    Husky mower sound like its running out of gas once it is started. We have changed the hoses and fuel filter. What else could be the problem
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #3

    Jul 8, 2012, 04:02 PM
    Hi,
    Bad fuel pump, clogged fuel cap or a dirty carb.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Huskee Riding Mower Clutch [ 0 Answers ]

I have a huskee riding mower and we just replaced the drive belts. They are too tight so the clutch will not engage fully until it had run for quite a while. After it warms the belt enough, it will engage better. It still does not engage to its full potential, however. Is there a way to just adjust...

My huskee riding mower start missing when I engage the mower deck 17.5 hp briggs [ 1 Answers ]

My huskee riding mower 17.5 hp briggs ! Starts missing running bad when I engage the mower deck

2005 Huskee riding mower PTO won't engage and mower dies [ 12 Answers ]

Replaced battery with new one, within several starts the new battery was drained. Mower will start by jumping but only runs a few minutes then dies, also the PTO will not engage at all (replaced PTO switch and still won't engage) does not even attempt to engage, as if there is no power to the...

Huskee Lawn Mower [ 1 Answers ]

I have a Huskee 808K Lawn Mower. I am trying to replace the PTO drive belt but having a problem removing the PTO Clutch pulley so I can put the belt on the top pulley. I removed the bolt but it still does not remove or Do I need to remove this? Any assistance would be great. Thanks,


View more questions Search