How to replace a push rod in a 18.5 briggs and stratton motor?

Check out some similar questions!

5hp briggs and stratton tiller motor need model # or replacement motor [ 3 Answers ]

I have an earthquake tiller model 5020 with a 5hp briggs and stratton motor that I need to replace but I can not find the model of the motor. Does anyone know which motor replaces that motor or do you know the model number of the motor that was used on that tiller?

How to replace the ring in a 12.5 hp briggs and stratton [ 1 Answers ]

My mower with a B&S 12.5 I/C Gold motor would not start. It has oil and gas coming out of the spark plug hole when you crank it over. If the little rubber boot is not hooked up to the carb when you try and start it oil pours out of it. Is my ring wasted or is the thing ready for the junk pile?

Briggs and stratton starter clutch threaded rod [ 4 Answers ]

I am replacing the starter clutch on a 10hp Briggs vertical shaft. I done this often in the past, but have never had this happen. Upon removing the starter clutch, instead of the clutch unscrewing from the post, the starter clutch and post unscrewed from the crankshaft. So now, I have a new...

Push rod bent on 16HP Briggs [ 3 Answers ]

Push rod is bent on 16 hp briggs and stratton - what are the possible causes

View more questions Search

Check out some similar questions!

Add your answer here.