Ask Experts Questions for FREE Help !
Ask
    twohawks360's Avatar
    twohawks360 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 5, 2012, 01:02 PM
    How to change a troy bilt powered push mower blade
    I hit a rock and my three hole blade came off. I don't see any screws.. just the blade.. I am purchasing a new blade but I don't know how to attach it back together.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Jul 8, 2012, 03:50 PM
    Hi,
    Sounds as if you may have broken the bolt in the center and the remainder is still in the crank. Liable to have one of two diamond shaped plates that fit push the blade against the adapter; one bows and holds the outer blade holes on pins cast into the adapter(replace diamond washer and adapter) or one with tabs that go through the holes in the blade and adapter( replace diamond washer with tabs.)
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy bilt 3.5 self propelled push mower won't fire even with a new spark plug? [ 0 Answers ]

Troy bilt 3.5 self propelled push mower won't fire even with a new spark plug?

Troy-bilt push mower? [ 3 Answers ]

I have a troy-bilt push mower it is self propelled 6.75 hp z start and it has problems it is hard to start and when I get it started it revs and dies in about 10 seconds sometimes it last longer about 5 minutes when it dies it normally won't start again for about 15 minutes please help!!

Troy bilt 6.75 hp push mower won.t start [ 1 Answers ]

My Troy Bilt 6.75 hp push mower won't start

Troy bilt push mower won't start [ 2 Answers ]

My troybuilt is brand new, has maybe 30minutes runtimt on it however it was in storage for ~2years. I tried to start it and it would only run about 5 seconds or keep running as long as I kept pumping the primer button. I opened the float bowl and it was gummed up. I cleaned the bowl and the float,...

Troy-Bilt riding mower blade removal [ 1 Answers ]

I'm trying to remove the blades but the nut on both blades won't budge. I sprayed them both with WD40 but still not happening. I got the mower up on jack stands so that I could at least sharpen the blades but they are in bad shape and still cut rough. I didn't want to try and loosen the nuts while...


View more questions Search