Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing fan motor relay switch with upgraded switch
[ 4 Answers ]
Hello, I've searched online to locate a replacement fan motor relay switch for an old Fedders propane heating unit in my greenhouse. The replacement should be fairly easy to do, however the part I was needing ( RBM 84-20103-301A) was listed as obsolete and was replaced by (McQuay part #...
Switch/Circuit board switch trips with Dehumidifier in basement
[ 1 Answers ]
Hi, I have whirlpool gold dehumidifier of 40 pint, running in basement for last 4 years, all of sudden it stopped working, when I checked it tripped the circuit board switch. I tried re-setting switch and plugged in the dehumidifier, it runs for 3 seconds and again switch trips. I tried in...
Connect a port on a remote switch to a secure segment on the local switch
[ 4 Answers ]
I have 2 Netvanta 1224R switches. On the main switch I have 3 Vlans setup. Vlan1 = main network (example IP 123.231.5.1) Vlan2 = Web Access (Example IP 69.115.851.202) Vlan3 = Secure segment (Example IP 123.231.8.1) On the remote switch I have 1 Vlan. Vlan1 = Main network (example IP...
HEAT-OFF-COOL system switch - AUTO-ON fan switch.
[ 2 Answers ]
Dear Gurus, I am a new house owner & not used to thermostats. We have Honeywell 8112D thermostat. We recently turned ON our Fan switch (in the thermostat). Now the fan is not turning off. It is continuously running even when the system is in OFF & Fan is in AUTO mode. We tried reducing the...
Converting pull switch lights to wall switch
[ 3 Answers ]
I've been struggling finding the answer to this in books and online, it seems as if it should be an easy question and something that gets done all the time. Looking for some help. My basement has several rooms and all lights are wired "hot" with pull switches from each light receptacle. When the... View more questions Search
|