Ask Experts Questions for FREE Help !
Ask
    obenski's Avatar
    obenski Posts: 14, Reputation: 1
    New Member
     
    #1

    Feb 17, 2011, 08:40 PM
    Engine Starts and Stop
    Managed to ground out my Tecumseh Engine for Snowblowers and it sparks. I have put little gasoline on the spark plug and the engine starts for about 2 minutes, then stopped. Tried to crank again, but never starts. It will start only a little when I put little gas on the spark plug. Any idea why not firing or starting the engine?? Thanks
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Feb 17, 2011, 09:07 PM

    You have something in the carb keeping it from getting fuel
    Probably need to remove and clean the carb.
    obenski's Avatar
    obenski Posts: 14, Reputation: 1
    New Member
     
    #3

    Mar 7, 2011, 10:48 AM
    I have removed the carburator and cleaned it very well like new. When starting, it's not going through. It starts only when I put a little bit of gas on the spark plug for about 5 seconds. Don't know what else to do to have this equipment keep running. I have separated the front main blade for snow throwing from the engine and I suspect that is nothing to do with that. Engine will start without the blade. Can someone help please?? Thanks a lot.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My Autostart remote starts the engine, but engine stops 3 seconds later? [ 1 Answers ]

When starting the car with the Autostart AS-2775 remote starter, the vehicle starts properly, but the engine stops 3 seconds later, and I cannot figure out why. The vehicle is a 2007 Toyota Corolla CE, bought used with the remote starter already installed. The other features work properly...

Hvac - furnace stop and starts [ 0 Answers ]

My furnace starts to turn on and as soon as it's about to blow air, it will stop. Eventually, it begins to work properly but takes a while to get going. Any suggestions?

Craftsman engine starts but shuts off [ 1 Answers ]

Turning key will not even turn engine over. Use jumper starter to start. Put park brake on to keep running. As soon as I disconnect black jumper cable engine shuts off. Occasionally engine will continue to run, but then when I try to engage the blade, engine shuts off. If I just touch the battery...

Blower starts and stop [ 9 Answers ]

I have a old Luxaire in my new home... I know it needs to be replaced but I need it to get me through the winter... Just last week I had someone come out and look at it they told me it was good and should get me through the winter... I turned it on yesterday it worked all day... late last night it...

Engine starts, won't engage [ 3 Answers ]

I have a 16.5 hp Craftsman Lawn Tractor (2001) Worked fine one day. Next day started fine, engaged and ran about five feet, jerked a few times. I shut off, checked it out. It started right up again, but would not engage. No motion forward or reverse. Sears tech support suggested parking brake...


View more questions Search