Ask Experts Questions for FREE Help !
Ask
    dilady's Avatar
    dilady Posts: 2, Reputation: 2
    New Member
    		  
    #1

    Mar 15, 2008, 08:17 AM
    Echo primer bulb
    How do I replace the primer bulb on my Echo grass trimmer model 1E SRM-2400?
    I purchased to part but can't get to the 4 screws to replace.
    Thanks
    Dilady
    biggsie's Avatar
    biggsie Posts: 1,267, Reputation: 125
    Ultra Member
    		  
    #2

    Mar 15, 2008, 06:08 PM
    Believe you need a 3 MM Hex Wrench -- to remove the motor housing screws

    http://www.echo-usa.com/pdf/document...T1E_092499.pdf

    Hope this helps -- please rate my answer
    dilady's Avatar
    dilady Posts: 2, Reputation: 2
    New Member
    		  
    #3

    Mar 16, 2008, 08:49 AM
    Thanks Biggsie but the primer bulb is located just behind the fuel tank cap but it's impossible to reach and has 4 tiny philips head screws. I don't know if I need to remove the fuel tank to have access to these screws. I will contact Echo tomorrow.
    Thanks for your assistance
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #4

    Mar 16, 2008, 11:12 AM
    Echo will have a diagram for you to look at probably. And yes, you probably will have to remove the tank, or other housings.
    biggsie's Avatar
    biggsie Posts: 1,267, Reputation: 125
    Ultra Member
    		  
    #5

    Mar 19, 2008, 10:03 PM
    I have been having problems getting a Ryobi leaf blower to run -- but I found

    The magic way to get it running -- Sea Foam is like a carberator cleaner

    I put some in a squirt bottle and put a little in the gas tank and a couple squirts

    In the carb intake... Really think this is a fantastic product -- TRY IT!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Weed eater featherlight, primer bulb [ 8 Answers ]

I have a weed eater feather light that will not run. The primer bulb has a sizable crack in it but I'm still able to make it prime but it won't run. Is the crack in the primer bulb keeping it from running or do I have another problem? Also, does anyone have a link for weed eater parts? The...

Primer Bulb [ 2 Answers ]

I have an older mower that runs OK. However, lately after about 10 min of running, it starts to choke out. When this happens, the primer bulb is sucked back into the mower. I can wait a few minutes or just manually pull the bulb back out and will run a few more minutes. What would cause the bulb to...

Primer bulb will not blow gas in the carb [ 1 Answers ]

I was given a Murry 4.5 bs mower and as soon as I put gas in, it started running out of the carb and primer bulb. I cleaned it really good with carb cleaner and replaced the float, pin and seat as well as the air filter gasket. It still will not put gas in the carb. When I was putting the...

Primer bulb for push mower [ 3 Answers ]

I have a push mower that only stays running when the primer bulb is pushed in. When I let go of the bulb, it quits running. Does this mean there is a hole in the primer bulb. When I hold the primer bulb in it runs like it would normally. Any suggestions?? :confused:

View more questions Search