Dumpy level and tripod screws don't match

wallroad Posts: 10, Reputation: 1

New Member

Sep 27, 2010, 02:08 PM

Dumpy level and tripod screws don't match

I have an old dumpy level (Powr Kraft 84-6463) and a modern construction tripod. Level has a male attachment screw with a fine thread, about 5/8". Tripod has a very coarse male screw, about 1/2". Any ideas on how to join the two?

Check out some similar questions!

Raising the level of a caste iron toilet flange to the level of the floor tile. [ 1 Answers ]

I have a similar problem as the person in a previous post. I installed one of those twist and sets PVC flanges right on top of my old caste iron flange but the top of the twist and set is still 3/8 inch below the tile. I am wary about using a double wax ring. Can I install one of those flange...

Medicine dropper beaker tripod graduated cylinder erlenmeyer flask test tube racks te [ 1 Answers ]

Just a quick question.

Screws below the level of the shower curb [ 4 Answers ]

In course of constructing my shower pan, I realized I would need to add a fourth 2x4 to my shower curb. This addition was to accommodate the need for an exceptionally thick mortar bed (drain located at the end of a 60" shower). Anyway, the new curb height is now slightly above the screws securing...

Tripod for Canon HF-100 [ 3 Answers ]

I have bought a Canon camcorder, model - HF-100. I was searching for the tripod that I can use with this . Can any body suggest, which tripod should I buy in the range $20 -$ 50 USD. Many Thanks Regards Gyan

Tripod alien book? [ 2 Answers ]

When I was in the 6th grade we read about a novel about a boy living on Earth, but humans were ruled over by tripods and I think all technology had been abandoned because I remember that the main character was surprised to see another person wearing glasses. Also at one point in the novel, the...

View more questions Search

Check out some similar questions!

Add your answer here.