Ask Experts Questions for FREE Help !
Ask
    tlavacque's Avatar
    tlavacque Posts: 5, Reputation: 1
    New Member
     
    #1

    Apr 18, 2009, 08:00 AM
    Craftsman riding mower stalls going uphill
    I have a craftsman riding mower and when I go uphill it seems to stall out. I have a feeling it is not getting gas because as soon as I get on a level part of my yard it runs fine. I am planning on getting a new fuel filter today but was wondering what else it could be? There was plenty of gas in the tank when it stalled out. Thanks for any help!
    andy52's Avatar
    andy52 Posts: 1, Reputation: 1
    New Member
     
    #2

    May 8, 2009, 06:00 PM
    My tractor was doing the same thing. I took carborator apart cleaned put it back togther, still stalls uphill. Found a piece of dirt in the opening on bottom of gas tank. Got the dirt out put tank back on running fine now. I guess it was not letting enough gas get to the carb. When needed the extra power for the hill. I hope this helps if not too late.
    tominpa's Avatar
    tominpa Posts: 1, Reputation: 1
    New Member
     
    #3

    Apr 25, 2012, 05:44 PM
    . My poulan tractor with a briggs & stratton vtwin 22hp motor would stall after mowing for about an hour. The fuel in the filter would be very low & bubbling. I suspected the fuel pump but after checking different message boards I wound up on a wild goose chase from bad cylender, push rods, head gaskets, carb seolenoid, float, etc. problem continued, engine running rough etc. I watched the fuel filter when the problem would occur & it was obvious the fuel was running backwards! Apparently the pump was bad and the system was operating as gravity feed & up hill was draining the carb. These fuel pumps can't handle alcohol well & our gas has alc in it (then again it was 4 years old). I got a new fuel pump on eBay for $12, runs like a champ, full power is back. I plan on ordering a backup. I hope this helps someone out there.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman riding mower stalls on turns [ 7 Answers ]

I have a Craftsmen riding mower about 6 years old on tight turns it backfires and sputters, almost stalling. It sometimes does the same on unlevel ground. It continued to do this even after I changed the plug and fuel filter. I just find it odd that turning the wheel tight would cause this to...

Riding lawn mower stalls [ 5 Answers ]

I have a new Craftsman model 917.28033 30" riding lawn mower. When I try to engage the blades the engine slows and stalls. I have tried engaging at full throttle while driving, and with the parking brake on at high throttle. I know it is something that I'm over looking. It was just delivered...

Riding lawn mower stalls when engaging drive [ 1 Answers ]

I recently purchased a used 8 year old 13 1/2 HP (B/S engine) 42" riding mower. It ran fine for one day. Now it will not allow me to release the brake pedal to engage drive without stalling out. I figure its something simple. Any help would be great! :mad:

12.5 hp B&S riding mower stalls under load [ 2 Answers ]

I am a novice mechanic. My 12.5 b&s (Murray) was leaking fuel from the carb. I put in overhaul kit for Nikki carb. Solved fuel leak. Now mower only runs when holding in clutch. Engine stalls when release clutch to engage drive belt. Thanks for your input.


View more questions Search