Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Older Craftsman Tiller w/5hp Briggs and Stratton
[ 11 Answers ]
I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...
Briggs and stratton carb?
[ 9 Answers ]
Got a murray push mower w/3.5 hp classic 9d902 2005 b2 00122851 b&s motor--primer bulb rotted away-installed new snap in bulb--opened up carb checked out for any gummy build up or bulb fragements -found none----primer won't squirt gas in carb unless you pour a little gas in carb--starts great then...
Briggs&Stratton Pulsa Jet Carb problems
[ 9 Answers ]
I'm having trouble starting an older aerator with a B&S 3.5hp horizontal shaft engine with a Pulsa Jet carb. I've changed diaphragm, and carb-to-fuel tank gasket. It can be started and run on starter fluid, but doesn't seem to pump gas into carburetor. What else to look for?
Briggs and stratton carb problems
[ 8 Answers ]
I have been having problems with my briggs and stratton 12.5hp motor! The carburator keeps getting too much gas into the float reservoir and gas comes out. I recently purchused a brand new carb and installed it but still seam to get too much gas to the carburator when I go to start it. Could it be...
How to adjust governor on older 8HP Briggs and Stratton mower motor
[ 1 Answers ]
I had to dismantle two engines to make one. Have forgotten how to adjust governor. I have fully closed buttefly in carby, and turned governor actuating lever fully anti-clockwise before re-tightening clamp on governor arm. Is this right or wrong? View more questions Search
|