Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Install Link Choke of Briggs & Stratton Engine
[ 10 Answers ]
The link choke of my Murray tractor engine is loose. I could not figure out how to put it back. Can someone help? A diagram will be super. The engine model is 28v707 type 1113e1. Thanks.
Briggs&Stratton won't run w/o choke
[ 9 Answers ]
There is no water in the fuel, replaced fuel pump diaphragm's and springs. Will start and run with the choke 7/8 closed, as I increase the throttle I can open the choke more until the throttle is wide and the choke is closed. Hellllp. It is on a 19.5 hp craftsman 42" mower ~ 8 years old. ...
Briggs & Stratton 16.5
[ 4 Answers ]
I have a MTD Mower OHV 16.5 B&S engine, Has New Battery , solenoid, starter, and valves have been set to .004 on intake .006 on exhaust. Will start and run till I shut it off and will not start again. It si only four years old. Any thoughts?
Briggs & Stratton 18 hp
[ 1 Answers ]
I have a troy built riding mower with an 18 horse briggs... this starter gear often sticks in the fly wheel and will not start unless you turn the fly wheel back by hand... I have replaced the starter and still have the same problem... the engine runs fine at all speeds but the problem still exists... View more questions Search
|