Ask Experts Questions for FREE Help !
Ask
    cinbearcat's Avatar
    cinbearcat Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 12, 2009, 06:08 PM
    Briggs & Stratton 16.5 hp difficult to start
    I have a B&S 16.5 HP engine on a riding lawnmower. I had the engine rebuilt last winter and it runs fine after it starts. The problem I have is that it turns over very slowly when starting. Once it does start, and I stop it (for example to fill it with gas) the battery runs down and it turns over so slowly it will not start again. I then charge the battery (I replaced the battery just a couple of months ago and had it rechecked - it is good) and then it will start up again (albeit cranking slowly). After trying to start it several times I checked the battery cables and they were hot.

    I had the repair shop check if compression is building up in the engine due to the exhaust valve not being adjusted correctly - they did a manual check by turning the mower by hand and said it is okay. He found that the base of the engine mount (a steel plate) was loose and suggested that it was not sufficiently grounded. I tightened up all of the bolts and thought that it was solved but still ended up having the same problem.

    I am pulling my hair out - any ideas are appreciated.
    Thanks.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 12, 2009, 07:18 PM

    Hi,
    First I would check the charging circuit. Check AC out of the alternator (28-36V) and the DC out of the rectifier (14.5V) to address your problems with the battery. I would not be surprised to learn that the rectifier has shorted and putting AC into your battery, the kiss of death.
    I think your cranking slow is the result of a weak starter; probably has some shorted turns on the windings.
    Not unusual for battery cables to heat up, though if you see melting that would be a bad sign.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

12.5 briggs and stratton won't start [ 18 Answers ]

I'm rebuilding the engine on my murray, it's a 12.5 horsepower power built. I have a brand new starter and the solonoid was replaced about a year ago, but it just clicks when I turn the key, if I hook up the starter and try and turn it over the solonoid clicks multiple times rapidly then won't...

12 HP Briggs & Stratton will not start [ 2 Answers ]

I have a 12 HP Briggs & Stratton Model 283707, Type 0148-01, Code 92042311. This engine broke a connecting rod. I have replaced the connecting rod. New rings also and do have it timed properly but it will not start. Turns over very good but will not start acts like it is not getting gas. New plug...

12.5 briggs & stratton won't start [ 1 Answers ]

This engine is on a trail cutter. Never had a problem starting the engine before. The last time I used it all went well . 3-weeks later I went to use it again . Checked the gas and it was out. Filled the tank and did the usual start up procedure and it would not fire. Put a little gas directly in...

Briggs & Stratton 5 HP - cannot start [ 2 Answers ]

I have a Coleman Powermate 2.2 kW 110 volt electric generator which uses a 5 HP Briggs and Stratton engine. I could start it without problems in December when we had a 4 day power outage near Seattle. It helped me out. Now I cannot start it. I tried new gasoline. By using ether (Faststart?) I...

View more questions Search