Ask Experts Questions for FREE Help !
Ask
    randyrdavis's Avatar
    randyrdavis Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 2, 2018, 09:56 AM
    Briggs and Stratton 14.5 model 287707-0224-01 Intake valve not opening
    Briggs and Stratton 14.5 model 287707-0224-01 Intake valve not opening
    ma0641's Avatar
    ma0641 Posts: 15,681, Reputation: 1012
    Uber Member
     
    #2

    Aug 2, 2018, 06:52 PM
    That is typical of a bad cam lobe, possibly a broken valve but I would suspect cam..

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs stratton 14 hp ohv I/c quiet model 287707 repair manual [ 1 Answers ]

Need to rebuild a briggs 14 hp I/C Quiet Engine Model-287707 Type-022002 Code-9309084A The Engine was run dry on oil but now it runs fine at high trottle but at low trottle it puffs white smoke and backfires every now and then should I put new rings in it or is it the head gasket and if it is does...

10 hp briggs and stratton ohv intake valve problems? [ 0 Answers ]

Should the intake valve slide in & out as easy as the exuast valve engine 204412-0136e1 Also how much lift or travel should the valves have?(I need to know if the cam is still good)

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01 [ 0 Answers ]

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01. Looked on the Briggs and Stratton site, was unable to find. Thanks in Advance

I need a intake valve seat inside the head of my b&s 287707 1272-e1 [ 1 Answers ]

I reciently acquired a murry lawn tractor and Ive had to do some work to it before I could get it running. Its sat behind my father in laws shed for around 2 years prior to me grabbing it. But anyhow, After a few minor repairs I got it running fairly good. Well today I was mowing the yard and all...

Briggs & stratton 14 hp 287707 backfires [ 2 Answers ]

New key on flywheel. Has spark. New sparkplug. Carberator cleaned thoroughly. Set fuel mix needle at 1 1/2 turns out. Installed new drive and starter drive. Adjusted valves. Cleaned valves and piston face. Still backfires out filter housing and exhaust. What are some solutions?


View more questions Search