Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
17 HP Briggs
[ 4 Answers ]
I have a 17 hp briggs OHV on a John Deer mower that is 3-4 years old. Have to move the flywheel past the compression stroke before the starter will turn the engine. Once cranked the engine spits pops runs about half throttle then dies. Noticed that it is blowing back through the air filter. ...
Engine switch V twin briggs for Briggs intek ohc
[ 2 Answers ]
I would like to exchange a 19 hp V Twin into a Craftsman lt 2000 mower. It was originally equipped with a 22 hp Intek V OHC. I am wondering how different the wiring is going to be. Also is this possible? The 19 HP twin is Model 42A777 Type 1236 01. The Intek is Model 407777 Type 0174 E1 Thank...
20 hp briggs
[ 2 Answers ]
I have a 20hp intek briggs it starts right up but loads up under a load it has a hydro trans
16.5 Briggs ohv oil in air box
[ 2 Answers ]
I have a Toro with a 16.5 single cylinder vertical shaft.Oil is dumping out of the crank case vent tube into the air box.It doesn't seem to burn any unless its over filled,Runs and starts fine , I have to add about a pint of oil each time I mow.Compression checks out at around 110.Anyone know...
12.5 Briggs won't run
[ 5 Answers ]
I posted a question earlier about a Murray mower wiring problem. Thanks for the info. I found the coil was dead and traced all the wiring. Now I am getting fire and gas, but it will not run - or even sputter. The key isn't sheared, and as far as I can tell the bottom end hasn't been opened, but it... View more questions Search
|