Ask Experts Questions for FREE Help !
Ask
    tableclocks's Avatar
    tableclocks Posts: 383, Reputation: 2
    Full Member
     
    #1

    Jun 17, 2018, 02:55 PM
    18 volt drill charger
    My porter cable cable 18 volt charger don't work, they don't make them any more, if I pin it correct can I use a 18 volt harbour or black and decker charger? Tks
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Jul 26, 2018, 10:33 AM
    There are places that rebuild Battery packs. If able to solder, you may buy the cells themselves and change out. Manufacturers use different methods for charging, 3rd terminal many times is for thermal detection/protection(keep the batteries from getting too hot. You may get lucky on Ebay.

    Found a Boatload here:
    https://www.google.com/search?q=port...Address&ie=&oe=

    Compare numbers or Photos

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Harbour freight 18 volt drill charger [ 3 Answers ]

Will a 18 volt batter charger, from harbour freight charge my 18 volt porter cable batterys as long as I have the + and - hooked up correct? Thks richard

Can I use1300ma charger instead of a 500ma charger [ 5 Answers ]

Hi, I have a Jump starter for my car which get charged when required with it AC adaptor output on charger is 12v dc 500ma 8watt, problem is this charger is faulty (no output) was going to buy a replacement charger with interchangeable jack ends it has an output of 12v dc and up to 1300ma, is this...

Obama: Drill, Brazil, Drill! [ 11 Answers ]

Words fail me...

480 volt transformer step down to 120 volt or 230 volt [ 1 Answers ]

AC Axial Fan: run on 120 or 230 input volts / Rated Currect .061 or .053 / Input Power 7 or 6 watts. Supply voltae 480. Need a step down transformer / 480 to 120 or 230 volts.

What kind of drill do I need to use to drill holes for 1 1/2" pvc plumbing. [ 6 Answers ]

I'm running 1 1/2" pvc for a basement bathroom vanity and a wet bar. Do I need to get a Forstner bit or is just a regular hole saw best for drilling my 2x6 wall studs? Also, is 2" the correct size, or should I go to 2 1/8" or 2 1/4".


View more questions Search