Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
6.HP Intek o/c Briggs & Stratton, breaking down under load then eventually dying.
[ 1 Answers ]
Hi, I have a 6.HP Intek o/c Briggs & Stratton on a mulcher. It hasn't been started for some time. I gave it a birthday, clean fuel, clean carby & air intake filter, dropped oil flushed sump, Checked spark and cleaned plug. (what is the correct gap)? Ran nicely at first just blew a bit of smoke....
Briggs & Stratton 18.5 HP OHV Intek Plus - Single Cylinder
[ 8 Answers ]
Help! I just replaced the short block on this motor and I cannot get it to run. I've adjuseted both intake and exhaust valves to 0.004 at 1/4 turn past TDC and no luck. It cranks over and kicks back on the compression stroke with smoke out the carb. So far it has not kicked over at all yet. What...
Briggs and stratton 14.5 I/C intek
[ 1 Answers ]
I need the compression spec for the Briggs 14.5 intek engine. Thank You Kindly Louis D'Amico
Briggs and Stratton Intek won't start
[ 9 Answers ]
Hi, I have a new Husquvarna LGT2654 (purchased March 29th) with the Briggs and Stratton Intek V-Twin. It's run fine until now. It's been extremely Hot & Dry in the Memphis, Tn. Area and it's been about 3 weeks since I had to cut the grass... Now it cranks and cranks but won't start. I... View more questions Search
|