I have a Briggs and Stratton 10HP engine (204412- 0276-E1) that I would like to put a starter on. I had back surgery and can not pull start my boys go kart any more. Does anyone know of a starter kit for this engine?
Check out some similar questions!
10HP Briggs and Stratton Generator Engine [ 24 Answers ]
Hi Guys, Recently, I was using my Generac 5550 generator with a 10HP Briggs & Stratton OHV, model 204412, Type 0142 engine, and it started running rough and puffing black smoke. So I bought the repair manual. Took everything apart to the piston, cleaned the carbon off the pistons and...
I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]
I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...
My briggs and stratton 10hp won't stay running for longer than 5 minutes. [ 0 Answers ]
I have had a dead short on my 10hp briggs and stratton ( motor number 251707-0149 ) and it would'nt charge. I replaced the stator so now the dead short is fixed, it is charging only slightly though. It will run for about 5 minutes or less then the ignition ( replaced points with electronic many...
Engine briggs&stratton 10hp [ 1 Answers ]
I require to buy 1 engine-brigg & stratton for use in a power plus generator. New or used. Thank you
Starting Briggs & Stratton 10HP engine that has not run for 2-yrs [ 5 Answers ]
Cleaned plug, put a little gas in chamber, put new gasoline in tank and still won't start after many tries. Has the old gasoline caused the problem and do I need to clean carb? Bronco Bob
View more questions Search
Add your answer here.