Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring an outlet for 230V welder?
[ 7 Answers ]
My building is 3 phase. How do I go about wiring a 230V receptacle? (1 phase) It is the Hobart 187 Mig. Do I need to put a brand new circuit in and wire in a new receptacle? The 3 phase/1phase has me confused. I bought the building off my uncle. He said there is a 220v outlet in here but he pulled...
Main to Sub Panel Wiring
[ 3 Answers ]
I received an answer prior to wiring this up, but am a bit confused. I think I was told to keep the ground separate at the sub panel but am not sure. If so, I only need to pull 3 wires (2 hot legs and 1 neutral). I have attached my PDF for your review. Thanks, ...
Load panel capacity 200 amp
[ 1 Answers ]
I have a challenger load panel SB20 (20-40) CT. Which is a 200 amp panel. The number of switches currently in the panel are 19 total. Total amp of all switches is 360. Some of those circuits are dedicated to a sole source. GFCI to Whirlpool tub for example. This panel has 20 1" spots...
Sub panel wiring
[ 1 Answers ]
I have a 50 amp GFCI breaker in my subpanel box to be used by a hot tub. I noticed that the breaker has a post for the neutral wire load. Is it necessary to use this post or can my load neutral wire be connected to the neutral bus (same as breaker pigtail and supply neutral)?
Wiring my garage for a 230 VAC single phase welder
[ 3 Answers ]
I am trying to wire a 220 outlet for my 230VAC single phase welder in my garage I have a 60a double breaker is it as simple as black and white w/ red stripe wires to breaker and green to ground? Thanks for any help View more questions Search
|