Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Voltage drop
[ 4 Answers ]
A 300sq mm cable is to be laid for 600mtr. Distance. As the distance is large so there are considerable voltage drop at the receiving side. How can we cope up with this voltage drop at the receiving end? We want a constant voltage ofd 415 V at receiving end irrespective of input voltage? ...
Best rewire solution to avoid voltage drop
[ 9 Answers ]
I need to replace existing wiring in a bedroom/office. The panel is located in a basement and NM can be run up a chase to the attic. From the attic, access to receptacle locations can be made through the wall plates down to the receptacle locations. The question concerns cable length and the best...
Voltage Drop
[ 2 Answers ]
I have a 20 amp breaker;there are a total of 7 receptacles on this circuit with a 15 amp GFI on the first receptacle. The first 5 receptacles in line work fine, the last two receptacles which are approximately 70 feet from the 5th receptacle flip the 15 amp GFI off when plugging in a drill. I...
Voltage drop. Is this normal?
[ 2 Answers ]
I live in a rural, small cabin (aprox. 50 yrs. Old) on a co-op electrical grid. The main panel with circuit breakers was recently installed (before I got here, 100 amp service) but the wiring was not replaced. It's the old two-wire (no bare copper ground). When I run certain circuits (220 well...
Voltage drop
[ 2 Answers ]
How far can you run an electrical cord, that is plugged into a 20 amp circuit, and still run a circular saw? If the saw starts slowly, will that harm the saw? View more questions Search
|