Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Plastic angle valve on copper - What is it?
[ 6 Answers ]
In my bathroom the copper stub out is connected to a plastic fitting which has a braided supply line fixed to it. Where the shut-off knob would normally be there is a circular piece of plastic which turns freely. Is this some type of quick connect fitting? I think I have a leak at the...
Copper Repipe
[ 4 Answers ]
I'm considering to copper repipe my home. The existing plumbing is galvanized pipe which are beginning to leak. I'm in the process of getting estimates for the job. What important questions should I ask the contractor when they're providing their estimate? Thank you.
Copper pipes to cpvc: still ground the old copper?
[ 1 Answers ]
Hi there... again... I have two copper stub outs that come into my garage, one the cold water in, which goes to my waterheater, and one hot water out, to the rest of the house, underground (slab construction). I will be re-plumbing my water heater and adding a bathroom from these lines, but I...
Copper into plastic
[ 2 Answers ]
Hi iwas replacing my floor because it was rotting when I was cutting some of it up I got into my copper supply line for the shower how can I tie into it with plastic because my soldering job turned out to be a big waste of time. Thank you for your help
Plastic and Copper pipe connections
[ 1 Answers ]
Help... I am trying to replace a kitchen faucet. The copper water supply pipe is connected to a plastic shut-off valve. I want to replace the plastic shut-off valve with a metal valve. The plastic shut-off valve will not come off the copper water supply pipe. How do I get this off? I tried... View more questions Search
|