Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace Failure
[ 7 Answers ]
I have a Coleman mid-efficiency gas-fired (propane) furnace tubular heat exchanger downflow hot air system. For about a month now I have had a intermittent problem with my furnace failing. The blower comes on with out any heat and produces a rapid red flash error code. This error code indicates:...
Blower failure on Gas furnace
[ 2 Answers ]
I have a Concord 80 plus gas furnace and the blower fails to initiate, causing the burners to shup down after just a few seconds. :(
Furnace periodic failure york
[ 3 Answers ]
I have an older furnace that seems to work fine. However, periodically it will stop working. Even though the thermostat has a call for heat, the furnace will not turn on. Then all I need to do is flip off the power for 10 seconds and it seems to reset it. As soon as I do that, it fires right...
Ignition failure carrier furnace
[ 1 Answers ]
Thk for the reply, I tried connecting a wire from the spark generator post and holding the other end 1/8 inch from the ground. First try a got a short burst of 3 weak sparks. Shut off furnace and re started this time no sparks a all. Checked that there was still voltage going to the SG unit. Guess...
Honeywell MagicStat/32 or Furnace Failure?
[ 4 Answers ]
I've changed the batteries on the thermostat when the "lo bat" message displayed. Per the user manual, I had to install the batteries backwards for 10 seconds in order to reset the unit. I then reinstalled the batteries in the proper manner and began to program the unit. Approximately 20 seconds... View more questions Search
|