Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Real thin-stone veneer; grout vs. Drystack
[ 4 Answers ]
I have some thin-stone veneer I am applying on a new home. I'm wrapping outside corners 27" a side and 72" high. Stone is Ledgestone-Colorado Buff Sandstone about 7/8 to 1 1/4 thick. The manufacturer and everyone I checked with in the trade says they don't use a brickledge. I wanted to dry stack...
Where can I get the dry stack stone ledge or panel like the one used in DIYnetwork
[ 1 Answers ]
I am looking and pricing the dry stack stone ledge or panel like the one used in DIY network Sweat Equit. Where can I get it?
Sub Panel Installation
[ 5 Answers ]
I'm looking to install a 100 Amp sub panel in my unfinished basement as the first step in completing my renovations on the lower level. The lower level is approximately 1000 sq ft (office, family/tv room, kids playroom and utility room). Here are a few key facts that might be useful to anyone...
Sub-Panel installation
[ 1 Answers ]
I want to install a 100 amp sub panel in a shed located approx. 100' from the main house panel. The shed is a wood work shop where I will be using a variety of power tools from radial arm saw to table top saw. Is the 100 amp panel sufficient? What size wire should I use, I was told 6/3G. I will be...
Natural stone veneer
[ 4 Answers ]
I'm planning to build a split face granite stone wall around my garage. Can anyone give me the ratio (shovels of sand, cement and/or mortar) to add for the mix. It's been years since I laid up a stone wall and don't remember it for sure. Also, any tips on cracking a stone, such as how to read the... View more questions Search
|