Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant 340MAV Fires and shuts down goes into code 34
[ 1 Answers ]
System cycles properly, Blower runs 90 seconds, gas valve opens, ignitor glows, gas ignites, nice Blue color, shuts down in 3-4 seconds, code 34 blinks on " ignition proving failure, furnace relights, does same thing and goes into Lockout. Tried re-setting Temp rollout safety switch. Could it...
Bryant 340MAV Blower Motor
[ 0 Answers ]
I have a Bryant 340MAV that the blower motor when bad in. I had a technician come out and replace the motor. The new motor does not seem to blow as hard. The first tech I talked to on the phone said that the OEM motor is a 3 speed motor. I am not sure but I think the replacement motor is a single...
Bryant 340mav trouble codes
[ 5 Answers ]
Bryant 340MAV giving trouble code 33. We replaced the filter - shut off the power for 30min to reset the code- worked for about 6 hrs. now it is showing code 33 again. Blower works, but heat won't kick on.
Bryant 340mav furnace?
[ 1 Answers ]
Furnace will fire up and run about 15-20min and I get a burnt smell through the registers. The furnace then shuts itself down. If I shut off all power to the unit and then flick the igniter switch a couple of times, the unit will fire back up and do the same thing all over again. Any ideas?
Bryant 340MAV Code 33
[ 0 Answers ]
Hi, I noted an intermittent heat issue with this model. I replaced a very dirty air filter. Now I get code 33. It would seem as though I am locked out. How do I perform a manual reset on this unit? I tried pushing the button on the rollout, but it doesn't seem to depress (very far... View more questions Search
|