Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Craftsman dys4500 won't stay running
[ 17 Answers ]
Skifreeq1 — New Member Sep 28, 2013 04:59 PM Hey people. Got a craftsman 917.28826 24 horse b&s intek motor. Just stopped running last night. Pulling the plugs, wet with gas. Checked for spark, had good spark. Plenty of fuel exiting the fuel line into the inlet for the carb. If I dump a little...
Craftsman weed eater won't stay running
[ 2 Answers ]
I have a 2 yr old 25cc Craftsman POS weed eater. It starts on one pull and runs perfect for about 3 minutes, then boggs out. I have replaced fuel lines and filters, replaced the gas with a perfect mix, cleaned air filter, and stripped down and cleaned the carb fully. I am real close dumping it...
Craftsman Riding Mower won't stay running.
[ 6 Answers ]
Craftsman Riding Mower 12.5hp B & S 917.25580 It will run great for 10 minutes, sometimes 20, sometimes 30. Sounds great when it is running. After replacing a slew of parts, it still dies like it is running out of gas. I can wait two minutes and it will start right up and run again for...
Craftsman Weedeater won't stay running
[ 5 Answers ]
I have a convertible craftsman weedeater that has run like a champ - until now! I can get it to run briefly, a few minutes at most, then it dies and will not restart. After reading some similar posts I am beginning to suspect either an in tank filter or the inlet filter on the card Sound...
Craftsman 16.5 OHV won't stay running
[ 3 Answers ]
I have a craftsman 16.5 IC OHV that I just replaced the fuel cylenoid switch on because it wouldn't crank without pouring gas into carburetor. Once I changed that, it ran for about 10 minutes then shut off. I was able to jump it off with jumper cables a couple of times, and it kept shutting off. ... View more questions Search
|