Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Copper Pipe - Try to bend, or replace?
[ 6 Answers ]
The pipe on the left in the picture not only looks bad, but will need to be moved back a bit after I shave down the stud to the right of it so I have an even surface to install backer board for a tile install. It is my understanding that the green stuff is flux leakage (these pipe was repaired a...
How to find a single copper water pipe in a group of copper pipes.
[ 1 Answers ]
Hi. I just bought a house with two apartments in a 2 story home. Apartment 1 is downstairs and apartment 2 is upstairs. I have separate water meters for each. I have separate water heaters for each. The water heaters and meters are in the basement. I just found out that somewhere in the house the...
Connection for copper closet bend to new toilet flange?
[ 0 Answers ]
Hi, I'm a plumbing novice learning the hard way. I'm remodeling a bath and the new floor will not be as high as old mortar bed, so I need to lower the toilet flange. The existing plumbing appears to be 3" copper pipe with cast (copper, brass?) closet bend. Tried to heat the flange to remove it...
Problem solve copper is in 2.154g of copper (1) sulfide
[ 3 Answers ]
How much copper is in 2.154 g of copper s Sulfide?
Bend 1/2" copper pipe 180 degrees
[ 4 Answers ]
Building a solar panel and need to run the pipe in parallel... View more questions Search
|