Ask Experts Questions for FREE Help !
Ask
    Hdavison22's Avatar
    Hdavison22 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 29, 2013, 12:57 PM
    Only 1 cycle
    I'm kenmore elite will only run 1 cycle. That is the perm press for 36 minutes. It only runs for 5 minutes then turns off so I have to go in and start the cycle again I do this until clothes are dry. I can not oust any other buttons other than start. Also during the cycle it continually beeps

    Any ideas on how to fix this?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    May 29, 2013, 01:26 PM
    I would take a look at the Timer and connections/contacts.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #3

    May 29, 2013, 10:38 PM
    See if this helps: https://dl.dropboxusercontent.com/u/...ng_Machine.pdf
    https://dl.dropboxusercontent.com/u/...sher_Elite.pdf
    Most likely you have a problem with the timer contacts being dirty or a bad connection at wiring harness. Frequently, vibration will loosen connections and this will cause your problem. You can bet it's something simple.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer runs fine on regular cycle, but shuts off during permanent cycle [ 1 Answers ]

Dryer shuts down during permanent press cycle

Whirlpool LSR9434PQ0 start cycle just hums but spin cycle it works perfectly [ 1 Answers ]

My Whirlpool washer model# LSR9434PQ0 will just hum when you try and start a wash cycle. If you rotate the timer to a spin cycle, it will work fine. I've looked at all of the wire harnesses and connections and there is no sign of a surge burn or a short. Any help would be great. I'm in the...

Cold cycle just trickles water into tub, hot/warm cycle fine [ 1 Answers ]

I have a roper washer, the cold water just trickles into tub but when put on warm/hot, water flows fine. Water going from water spigot to rear of machine is fine. How do I raise lid of washer, also?

Carrier furnace purge exhaust fan continues to cycle and cycle [ 3 Answers ]

Carrier furnace/AC Product model #58ZAV 075-101JC Model #58ZAV 075-JC Series 100 Serial #2093A16 303 Natural Gas/Propane, heat furnace runs on Propane. Problem: With the unit turned to cooling with the thermostat, the heat pre-purge exhaust fan continues to cycle on and off, sometimes...

In Plants: Light Cycle vs Dark Cycle vs Calvin Cycle vs Cellular Respiration? [ 1 Answers ]

Can someone explain to me the difference between these? I am trying to write a lab report and have no idea what I'm writing about.

View more questions Search