 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Evcon gas furnace troubleshooting
So I have tried to get my propane Evcon Furnace to start up and it seems everything is going OK then it turns off. It tries to start 3 times then it powers off.
I am getting a blinking light from the panel. The"sourse" light blinks 7 times stops and repeats... any ideas? |
||||
Check out some similar questions!
The regulator clicks and the furnace does not light.
I have a Coleman Evcon Furnace, Model # DGAT070BDC. Sometimes it will kick on but never ignite, just keeps running. If I turn it off for about 10 seconds, then turn it back on it usually works.
Indusor motor comes on, then ignitor glows, flames up and then goes out in few seconds. Does this three times, and locks out with ignition failure as code. Replaced flame sensor already. It is one that has centrifical switch instead of pressure switch # DGAT 056 BDD
I have a coleman evcon direct vent forced air furnace (gas with electric ignition). The motor runs, but it does not ignite. The blowers work fine on fan mode but will not ignite or blow on auto. Any suggestions?
Model# DGAA070BDTB It will ignite then shut off almost instantly then try to ignite again until blower motor comes on it then tries to ignite a few more times till it shuts off and shows a steady red blink. I have replaced flame rod sensor and checked limit switches for 24v all are OK. I replaced...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
