Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Extending utility sink drain for bar sink
[ 2 Answers ]
I have a utility sink in my walk-out basement - that sink's 1.5 inch drain connection is approx. 18" above the floor, into a two inch horizontal run. This 2 inch horizontal PVC runs about 3 feet, then connects to a main 3" DWV. I would like to add a bar sink, set into a standard height (36")...
Kitchen Sink/Laundry Sink Drain Vent Non-exist
[ 3 Answers ]
The set-up from kitchen sink leading down to drain to basement: 1. Kitchen sink - (R side) - connected to a P drain I think you call it -PVC-, connected to a "metal" T, which has a Studer vent gizmo attached to the top of it, then draining into a metal pipe straight down to the drain in the...
Repairing hairline crack in 1920s utility (laundry) sink
[ 1 Answers ]
I just bought a house that has an old concrete double basin utility sink. The right basin has a hairline crack and leaks water. I'd hate to sledge and remove it and was hoping this is fixable. Any suggestions?
Adding a utility sink
[ 1 Answers ]
I am planning on adding a utility sink to my laundry room, I was planning on tapping into the water lines and drain to the washer. I have not opened up the wall yet so I don't know the exact configuration of the drain, but my question is if I run the sink drain of off the drain from the washer...
Installing a utility tub
[ 7 Answers ]
Hi, I want to install a utility tub in my laundry room. My question is, can I tee the tub drain into the washer drain stack? I really don't want to run a separate drain pipe all the way to the main stack ( about 30ft). About the house; single story, crawl space, laundry room at back of house,... View more questions Search
|