Ask Experts Questions for FREE Help !
Ask
    bmetzger64's Avatar
    bmetzger64 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 27, 2012, 12:11 AM
    Coleman evcon furnace troubleshooting
    I have a Coleman Evcon Furnace, Model # DGAT070BDC. Sometimes it will kick on but never ignite, just keeps running. If I turn it off for about 10 seconds, then turn it back on it usually works.

Check out some similar questions!

Coleman evcon furnace troubleshooting? [ 5 Answers ]

The regulator clicks and the furnace does not light.

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon furnace troubleshooting [ 1 Answers ]

Indusor motor comes on, then ignitor glows, flames up and then goes out in few seconds. Does this three times, and locks out with ignition failure as code. Replaced flame sensor already. It is one that has centrifical switch instead of pressure switch # DGAT 056 BDD

Coleman evcon furnace troubleshooting freezing inside coils [ 1 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.

Troubleshooting Coleman Evcon Furnace? [ 1 Answers ]

I have a coleman evcon direct vent forced air furnace (gas with electric ignition). The motor runs, but it does not ignite. The blowers work fine on fan mode but will not ignite or blow on auto. Any suggestions?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.