Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring a furnace thermostat to manually operate the furnace fan
[ 2 Answers ]
I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?
Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset
[ 5 Answers ]
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
My intertherm furnace pilot lights but furnace won't kick on
[ 5 Answers ]
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...
Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work
[ 1 Answers ]
I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...
Luxaire heat pump
[ 1 Answers ]
Older model luxaire heatpump will blow warm air in heat mode for several minutes then star blowing out cold air. Unit has new filter and coils are clean. The blower motor. Condensing motor and compressor run but blows cold air. Any suggestions on what problem could be? View more questions Search
|