Ask Experts Questions for FREE Help !
Ask
    Rhparker52's Avatar
    Rhparker52 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 24, 2012, 10:04 PM
    04 dyna wg twincam
    Hit a big oot hole and motor died. Wwont start. Have swapped coils, ignition module, power is on and seema to be everywhere. Fuel but no fire. All fuses are good, can't find a short in wiri g anywhere. Lost

Check out some similar questions!

Dyna Glo Kerosene Heater (RMC 95-C2) [ 2 Answers ]

I just changed the wick in my heater and now the flame isn't as high as it used to be. I have changed wicks in this before but this is a first for not getting the full heat output out of this heater. Any suggestions would be greatly appreciated! Thanks.

Dyna-glo ventless gas heaters [ 0 Answers ]

I have a dyna-glo model RMC-40NGT, and the pilot went out. I followed thr relighting instructions, the pilot relit, but when I turned the knob to "on" the pilot went out. HELP! It's cold in here!

Toyota Dyna fuel consumption [ 1 Answers ]

What could be possible reasons for a high fuel consumtion (4.2 km per liter) for my 3 ton Toyota Dyna truck?

Dyna-Glo Kerosene wick won't stay up [ 4 Answers ]

I have a Dyna-Glo Kerosene (RMC-95-C2) heater, After attempting to change out the wick, I installed raised and it wouldn't lower. So I took it back apart. When I went to raise itagain, It would not. It doesn't click and immediately falls back to extinguished position. I haven't even...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.