Ask Experts Questions for FREE Help !
Ask
    Greg7greg's Avatar
    Greg7greg Posts: 7, Reputation: 1
    New Member
     
    #1

    May 11, 2012, 03:42 PM
    How hot does the furnace controls get?
    I need to replace the hoses to the air pressure switch in my furnace. The two types of hoses I tried both melted. How hot does that area get so I can buy the correct type of hose.
    Greg

Check out some similar questions!

Hot water problem with shower controls? [ 0 Answers ]

My shower control knob although turned all the way to the right is not producing much hot water.

Older natural gas furnace controls [ 0 Answers ]

The blower motor of my older carrier 50K BTU unit became noisy. I removed the motor to get the part info. Normally I would mark the wire locations, but since I was just moving the control board to the side to remove the blower, I didn't mark them. When I re-assembled the unit, I noticed that a...

What causes breaker with bad GFCI to run controls but not pumps on our hot tub? [ 6 Answers ]

240V breaker with bad gfci(wouldn't do anything when you pushed test)runs the controls on the spa but won't power on the pumps. Relay just clicks. When I installed a new breaker with good gfci the breaker trips immediately. Any ideas as I'm ready to sell the hot tub and want it to work properly. It...

Shock feeling when touching hot/cold water controls in bathtub [ 3 Answers ]

My daughter said she felt a slight prick ( I was guess like a shock feeling) when she touch ed the knobs while taking a bath? Needless to say my daughter got out ot the bath ! Never had this happen before. Sounds bad to me.


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.