Ask Experts Questions for FREE Help !
Ask
    01061959's Avatar
    01061959 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 22, 2007, 10:19 AM
    Trante furnace
    I have a two stage furnace which is a hot surface igniter type the furnace comes on the exhaust fan comes on and the igniter lights the burners but the fan does not come on and the sytems shuts down
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Feb 22, 2007, 09:24 PM
    Bad blower motor, capacitor or circuit board, I'm leaning toward a new Trane circuit board.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #3

    Dec 26, 2008, 08:01 PM

    If you set the tstat to fan /fan only,does the blower work or still not work?, cheapest thing to replace 1st would be the capaciter, just make sure its an exact replacement
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #4

    Dec 26, 2008, 08:02 PM
    Where are these year old questions coming from,,
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

New furnace [ 9 Answers ]

I have got an old furnace I am going to have to replace eventually. I was looking for general advice right now what I should know when finding someone to replace it. I don't want to get into a situation where it will cost me thousands of dollars when I don't need to. I have a gas furnace with hot...

View more questions Search